FAQs
Do you allow pets?
Yes, we do.
Spare Tires
Every van has a spare tire.
Removing the Spare Tire and Tools Equipment needed for a cargo van or a passenger van is in the passenger side rear corner of the vehicle.
Remove the retaining wing bolt and lift it off of the mounting bracket. Equipment needed for a 15-passenger seating arrangement is secured on the rear floor on the passenger side of the vehicle. Remove the retaining wing bolt and lift it out of the mounting bracket to access the equipment.
1. Assemble the wheel wrench (7) to the hoist handle and the extension(s) (6). 2. Open the passenger side rear door. 3. Insert the chisel end of the hoist handle, on an angle, through the hole in the rear floor panel above the bumper. Be sure the hoist handle connects to the hoist shaft. The chiseled end of the hoist handle is used to lower the spare tire. 4. Turn the wheel wrench counterclockwise to lower the spare tire to the ground. Continue to turn the wheel wrench until the spare tire can be pulled out from under the vehicle.
5. Remove the wheel wrench, extension(s), and hoist handle assembly from the hoist shaft. 6. When the tire has been lowered, pull it closer to reach the tire retainer and pull it up through the wheel opening. For a vehicle that was completed from a cab and chassis, refer to the information from the body supplier/installer. The spare tire is a full-size tire, like the other tires on the vehicle. 7. Put the spare tire near the flat tire. 8. Close the passenger side rear door.
Removing the Flat Tire and Installing the Spare Tire If the vehicle has plastic wheel nut caps, loosen them by turning the wheel wrench counterclockwise. The wheel nut caps are designed to remain with the center cap. Remove the center cap. If the wheel has a smooth center piece, place the chisel end of the wheel wrench in the slot on the wheel and gently pry it out
4. Wheel Wrench 5. Jack Handle 1. Do a safety check before proceeding. See If a Tire Goes Flat 0 273. 2. Loosen all the wheel nuts with the wheel wrench. Do not remove them yet. 3. Assemble the jack and tools: Front Flat: Assemble the jack (1) together with the jack handle (5), one or two extension(s) (3), and the wheel wrench (4). Rear Flat: Assemble the jack (1) together with the jack handle (5), two extensions (3), and the wheel wrench (4)